Piezoresistive pressure sensor with a rectangular diaphragm

len         length or longer edge of the diaphragm in µm
wid        width or shorter edge of the diaphragm in µm
thc         thickness of the diaphragm in µm
pre        full scale pressure in psi
pois       Poisson's ratio
ymod    Young's modulus of the material in GPa
              Use 1 for sensitivity and 3 for burst pressure


Diaphragms or membranes as it is sometimes called, form the basic structural element of MEMS pressure sensors. They are easy to fabricate, offer good dynamic response and can be used over a wide range of pressures. In this model, the outer edges of a rectangular diaphragm are held firmly and a uniform pressure amounting to the full scale pressure is applied from top. The applied pressure will deflect the diaphragm till the elastic forces balance  the pressure.

The piezoresistor should be located at maximum stress locations near the edge, at the center of the longer side of the rectangle. The relative change in resistance of the piezoresistor is related to the stress, the piezoresistive coefficients and the angle of placement with respect to the edge of the membrane. Typically four piezoresistors, two placed longitudinally to the stress and two placed transversely are connected in a Wheatstone bridge.  Alternately, two resistors could be placed at the outer edge and two towards the center of the diaphragm keeping their orientation the same. The relative change in resistance of the piezoresistors are registered as an output voltage proportional to the supply voltage connected to the bridge. The supply voltage is assumed to be 5V. The piezoresistors are assumed to be of p-type with rectangular shape.

This design interface can be used to determine the sensitivity  and burst pressure of a rectangular diaphragm. Sensitivity is defined as the change in output voltage for a unit change in pressure at 5V supply. The output at any other supply voltage can be calculated from this. Burst pressure is a theoretical limit for the pressure that can be applied to the diaphragm without rupturing the diaphragm. The maximum allowable stress is assumed to be 2GPa for this calculation. This could vary depending on the features peculiar to the given membrane like etch deformities and defects.

The plot shows the span of the pressure sensor as a function of membrane thickness. Span is the output of the sensor at the full scale pressure and 5V supply to the Wheatstone bridge circuit. Using the crosshair tool, the span at any diaphragm thickness can be estimated.


-The default material is (100) Silicon with a Young's modulus of 180GPa and Poisson's ratio of 0.3.
-The diaphragm has uniform thickness.
-The diaphragm is assumed to be held rigidly at the outer edges. In reality it may be slightly flexible.
-The property of the material remain constant across the diaphragm.
-The diaphragm is not subjected to any pre-stress and the pressure is the only load acting on it.
-The piezoresistors are placed at the maximum stress locations oriented to give the maximum change in resistance.
-The piezoresistors are connected in a Wheatstone bridge with 5V supply.
-The influence of temperature variation is not considered
Menu Path

Sensing > Piezoresistive > Pressure > Rectangular diaphragm

© MEMSolver.com. All rights reserved.