Use 1 for maximum stress and 2 for maximum deflection and 3 for spring constant of the beam

**Notes**

Use this form to estimate the bending of a cantilever beam due to
an end mass. The maximum stress is at the top surface near the
clamped edge and the maximum deflection is at the free end. The
plot shows the deflection of the beam along the length of the beam.
Using the crosshair, the deflection at any point along the length
of the beam can be obtained.

-The default material is Silicon with a Young's modulus of 180GPa.

-The beam has uniform cross section.

-The bending of the mass is negligible

-There is no other load acting on the beam other than the gravitational pull on the mass

Mechanics > Structures > Beams > Cantilever > Mass at free end